Home Page Image
     single servo or

dual servo (acts as buffered Y)


IDEAL FOR LONG AILERON AND TAIL CABLE RUNS
 

 
  sb1  
sb1
Pay attention to the plug's polarity as damage may occur by incorrect placement.
 

 

The Servo Buffer is a device that boosts the signal whenever we have long cables between the receiver and the servo.

SB1 can drive up to 2 servos from a single channel.

It is cascadable which means that you can use two in line for extra long cable runs.

It does not boost up the power delivered to the servo (this can only be done by using thicker cables) but only the signal routed so to minimize servo jitter.

Dimensions 30 X 10 X 8 mm
Weight 5gr (cable incl.)
Operating votage 3,3V - 6V DC
Curent drain 1mA ( with no servo attached)

 

 

 

     
Copyright © 2007-2010 by Grele"   •   All Rights reserved   •